Eye Wash Standard

The ansi z358 1 eyewash standard was first implemented in 1981.

Eye wash standard.

This standard written and published by the international safety equipment association isea an ansi accredited standards developing organization establishes minimum performance and use guidelines for eyewash and shower equipment for the emergency treatment of the eyes or body of someone who has been exposed to hazardous materials. This includes flushing the system and using only solutions appropriate for flushing eyes. The emergency shower should deliver a pattern of water with a diameter of at least 50 8 cm 20 inches at 152 4 cm 60. Ansi z358 1 recommends a flow of 0 4 gpm also at 30 psi.

The ansi z358 1 2014 standard establishes a universal minimum performance and use requirements for all eyewash and drench shower equipment used for the treatment of the eyes face and body of a person who has been exposed to hazardous materials and chemicals. This standard ansi z358 1 is intended to serve as a guideline for the proper design certification performance installation use and maintenance of emergency equipment. If none of the materials used in this work area is an injurious corrosive chemical as indicated by the material safety data sheet msds for each product then an emergency eyewash or. Eyewash standards regulations overview in many workplace environments it s impossible to eliminate an employee s risk of accidental particulate or chemical exposure.

National standards institute ansi has established a standard covering emergency eyewash and shower equipment. Eyewash stations target just the eyes and therefore have a lower flow requirement. An eyewash gauge should be used to verify and test the flow pattern. All dimensions and measurements are taken from the american national standards institute ansi standard z358 1 2014 emergency eyewash and shower equipment.

However you can protect your workers through education training and with personal protection equipment ppe needed to prevent or respond to workplace accidents. The nozzles should be at least six inches from any obstruction and mounted between 33 and 45 inches above the floor. It was issued in 1981 and revised in 1990 1998 2004 2009 and again in 2014. However not all dimensions and measurements required by the ansi standard are listed here.

Ansi isea z358 1 is a national consensus standard that helps users select install operate and maintain emergency eyewash eye face wash and shower equipment. Self contained eyewash units must be maintained and employers should consult the manufacturer s instructions for maintenance procedures.